[Documentation] [TitleIndex] [WordIndex

Swiftpoint SM300 Disassembly

The following instructions describe the process of disassembling a Swiftpoint SM300 wireless laptop mouse. One can be purchased here.

The following video shows an example of the SM300 being disassembled.

Instructions

Remove contact pads from bottom of mouse.

wouse_build_1.jpg

Remove 2 screws

(1 at front, 1 at back of mouse, under contact pads)

wouse_build_2.jpg wouse_build_3.jpg

Remove the top cover

Includes 2 buttons, lights, red grip, swiftpoint label, etc.c. It can be pried off (note 5 plastic mechanical clips. Start with these)

wouse_build_4.jpg

wouse_build_5.jpg

Unclip flexible cable from mount on the board.

wouse_build_6.jpg wouse_build_7.jpg

Remove screw near rear of mouse.

wouse_build_8.jpg

Un-solder flexible circuit at top rear.

Or cut away, or pull hidden portion off of inside of case.

wouse_build_9.jpg wouse_build_10.jpg

Pry open clip at top of mouse.

wouse_build_11.jpg

Carefully separate frame with buttons, wheel, battery mount from base.

Battery is glued into slot, and wired to circuit board.

wouse_build_12.jpg

Pry battery free from slot.

wouse_build_13.jpg

Unsolder charging wires from plastic base.

wouse_build_14.jpg wouse_build_15.jpg

Remove plastic lens from base.

It is just resting in place.

wouse_build_16.jpg wouse_build_17.jpg

Glue lens to bottom of circuit board

Place a small dot of glue on chip and lens, away from optics.

wouse_build_18.jpg

Finished


2024-11-02 17:30